Contribute
Register

Post-Installation Issues

Status
Not open for further replies.
Joined
Apr 30, 2012
Messages
85
Motherboard
GA-B75M-D3H
CPU
i5-2500K
Graphics
Intel HD3000
Mobile Phone
  1. Android
Hey!

Just finished installing the macOS Public Beta preview. Followed this tutorial and was able to boot into my SSD using the Installation USB.

But I can't get my post-installation right. I'm having some issues with graphics and HDMI audio (but the latter I think I can fix later). My graphics card is the built-in from i5-2500K, the HD 3000. On El Capitan, I used to inject the device ID at IntelGFX, Devices and Properties at Device section on Clover.

Can't get it working on i) main SSD with Device ID injected, or ii) Installation USB with Device ID injected, or iii) main SSD without Device ID injected. However, Installation USB without Device ID injected works just fine. But without proper graphics card recognition (at 1024x768 resolution and HD 2000 3 MB graphics, but it should be HD 3000 384 MB).

I'm using two displays, one DVI and other HDMI (tried with only one plugged in and the problem persists).

My Clover version is v3599. Kexts: FakeSMC, NullCPUPowerManagement and RealtekRTL8111 at S/L/E and Clover /other folder, both at the Installation USB EFI and SSD's EFI as well. Config.plist and verbose's last line attached.

Any thoughts?
 

Attachments

  • config.plist
    2.8 KB · Views: 533
  • IMG_20160710_010707511.jpg
    IMG_20160710_010707511.jpg
    2.5 MB · Views: 2,918
Last edited:
There are many gpus having the same issue after post install there is no gfx, i think you will have to for future and updated drivers. and this happens even in real macs, Sierra is not yet stable at all.
 
There are many gpus having the same issue after post install there is no gfx, i think you will have to for future and updated drivers. and this happens even in real macs, Sierra is not yet stable at all.

Even in real Macs? Oh.

Nobody with a similar setup got it working?
 
UPDATE

Installed Clover v3602 at my main SSD, renamed 10.11 folder to 10.12 and copied FakeSMC & NullCPUPowerManagement & RealtekRTL8111 there. Installed them again with Multibeast (setup attached).

Now I can (finally) boot into my main SSD directly from the UEFI BIOS. But i) Graphics isn't working (even though it's injected at config.plist — attached) and ii) sound isn't working as well.

Any thoughts?
 

Attachments

  • Screen Shot 2016-07-11 at 17.01.00.png
    Screen Shot 2016-07-11 at 17.01.00.png
    78.8 KB · Views: 2,300
  • config.plist
    4.9 KB · Views: 442
Status
Not open for further replies.
Back
Top