- Joined
- Jun 15, 2012
- Messages
- 519
- Motherboard
- Gigabyte Z370 AORUS Gaming 7-F13
- CPU
- i7-8700K OC @ 5.1Ghz
- Graphics
- RX 6900 XT
- Mac
- Classic Mac
- Mobile Phone
I updated my perfectly working 0 issue clover from r2976 to 2988 with same configuration and installation setup across the board, and the new version would not post at all. it'd literally loop back to bios. I tried every fix imaginable. I tried UEFI, non UEFI. USB flash drive boot, hard drive boot. no matter what the new version was unbootable.
I reinstalled 2976 and low and behold, 100% working again. I guess my lesson as a new clover user, once it's working, don't update it, EVER. I have since removed pref pane and auto update checking and I will not be updating this bootloader again until probably 10.11 when it's required, and when I do I'll take extra caution in doing so.
All I can say is whatever happened between 2976 and 2988 is very bad.
I reinstalled 2976 and low and behold, 100% working again. I guess my lesson as a new clover user, once it's working, don't update it, EVER. I have since removed pref pane and auto update checking and I will not be updating this bootloader again until probably 10.11 when it's required, and when I do I'll take extra caution in doing so.
All I can say is whatever happened between 2976 and 2988 is very bad.