Contribute
Register

Ersterhernds i7 Cube Build Guide

Status
Not open for further replies.
Thx Rick!
(still waiting for your Cube to continue...)
 
Amazing guide :thumbup:
Mind explaining a little about the touch switch?
Mainly where you got the 5V power and how you connected it to the front panel header, if it's not much to ask :oops:
 
CustoMac Mini
GA-H61N-USB3 |  i3 2105 |  HD 3000
teraflow said:
Amazing guide :thumbup:
Mind explaining a little about the touch switch?
Mainly where you got the 5V power and how you connected it to the front panel header, if it's not much to ask :oops:
Click to expand...

Thx teraflow!

The 5V for the Edisen sensor is found on pin 9 of the Custom Solutions Header, as it supplies constant 5V Standby power. The Power Switch is connected to pins 7 (PWRBUT) and 2 (GROUND) on the same Custom Solutions Header. This leaves the motherboard power switch header open for use by the original bottom mounted PWR/RES switch on the Cube.

In essence, there's two power buttons on two separate circuits. Its one of the terrific features of using the DQ77KB in a Cube.


Hope this helps...

Cheers!

(EDIT : I added this into Step 18 of the Guide)
 
I will know when I receive the touch sensor I bought, since we have different motherboards I'll have to try :think:
Thanks for the tips, they clarify how it works :)
 
CustoMac Mini
GA-H61N-USB3 |  i3 2105 |  HD 3000
Status
Not open for further replies.
Copyright © 2010 - 2024 tonymacx86 LLC
Back
Top